I²S Electrical Validation

Use an oscilloscope for I2S electrical validation to ensure compliance with defined specifications. After an extended burn-in test, the oscilloscope confirms that the electrical characteristics of the signal meet the required standards.

Supported Models:

TS3124V (4-channel DSO)	TS3000 Specifications PDF	MSO3124V (4-channel DSO + 16-channel LA)	MSO3000 Specifications PDF

Overview Report

Reference Point Dialog & Waveform:

HTML Report

I2S Electrical Validation Settings

1. General Settings: Channel sources, working voltage and speed

2. Decode Settings:

3. Trigger Settings

4. Electrical Validation Parameter Settings: Frequency, Timing, Voltage limitation

This section displays 3 characteristics table, including 1. Frequency 2. Timing Parameters 3. Voltage requirements The default values are referenced from the I2S specification rev3.0.

6. Software EV control panel

Stop Conditions: Stop when acquired X times Stop when Result Fail > X times Information: Select waveform Save File: Save as Html Save as .MOW (Software format)

 

Electrical Validation Solution PDF