BF7264B

Option	BF7264B	BF7264B+
eMMC 5.1	Yes	Yes
MIPI D-PHY 1.2	Yes	Yes
NAND Flash	Yes	Yes
SD 3.0 (SDIO 3.0)	Yes	Yes
SD 4.1	Yes	Yes
SGMII	Yes	Yes
UFS 2.1	NO	Yes
Logic Analyzer Probe	Yes	Yes

 

Protocol Analyzer: eMMC 5.1, MIPI D-PHY 1.2, NAND Flash, SD 3.0 (SDIO 3.0), SD 4.1 (UHS-II), SGMII

• Real-time data display, post-capture waveforms
• Trigger for commands or data
• Different active probes for different protocols for easier connections
• Filter data to save more commands
• Hide data for easy reading
• Search data for quick finding
• Statistics for commands and data
• Two voltage detects to find design bugs from voltage drop
• Use PC hard disk (SSD) to log long time data
• Protocol monitor like dash camera for long time surveillance (months)

Logic Analyzer: eMMC 5.1, NAND Flash, SD 3.0 (SDIO 3.0), Serial Flash, SPI

• 2.4GHz timing analysis
• 8-state flow chart bus triggers
• Bus decodes with waveforms
• Stacks with a DSO to form as an MSO

 

Logic Analyzer (LA) Mode

• MSO analog and digital channels can capture signals simultaneously.
  It can also stack an oscilloscope to compare digital and analog signals simultaneously, which is suitable for signal quality analysis.

  LA Storage Mode:
  Long Time Record: Transitional Storage VS Compressed Storage
  For signal capture and analysis, usually require to record the signal for a long time. If the data is stored in a compressed way, it will cause your software to lag or even stop functioning when decompressing the data after it is sent back to the computer. Because PC memory size might insufficient for decompressed data size. To satisfy the requirement of smooth software operation and long-term recording without missing any data, the storage method adopted by the Acute analyzer is transitional storage rather than compression. After returning to the PC software, it doesn't need to do the decompression. The decoded results can be displayed while the analysis is finished. 
  
  
  
  Software Main Window
  
  Analog & Digital waveform
  Auto Threshold Settings:
  1.
  2.
  3. 
  
  Trigger Settings Window
  
  Multiple Protocols Analysis Simultaneously:
  Ex: I^₂C + USB PD3.0
  
  
  MSO Stack With Other Vendors of Oscilloscope:
  (*Support DSO)
  
  MSO Enables Digital & Analog Channels (Using the same channels)
  Digital & Analog Signals From MSO and External DSO From Other Vendors*BUS_SMBUS: Decode & Digital Signals   *DSO: MSO Analog Signals   *Ext DSO: External DSO Signals
  
  Add Notes & Pictures in Waveform
  Power Management Protocols Solution for MSO
  Ex: PMBus(CH0 & CH1) & The Related Power Voltage(CH2) (*Digital CH0, CH1    Analog: CH2 )
  

Protocol Analyzer (PA) Mode
It is hardware decoding, may log protocol data very long time if without waveforms.
Application timing: Preliminary protocol debug.

PA Storage Mode:
Software Main Window: